Elinchrom 4 IT, 2 IT operation manual EL-Skyport Eco Features, Power save mode timer

SET Config Mode:

(to configure included features only with MAC°/ PC° EL-Skyport Software V. 3.0)

-Switch the module OFF // remove battery..

-Hold the Test button down whilst you insert the battery..

-Keep test push button pressed until STATUS LED is ON.

Please check also EL-Skyport PC/MAC software 3.0 for changing Transmitter setting.

EL-Skyport Eco Features

Power save mode timer:

-After not using the Transmitter for 30 minutes the Power Save mode is active. To reactivate the Transmitter, press the TEST push button.

-The Power Save mode timer can be configured with the EL-Skyport PC/MAC software v3.0 and higher.

Status LED:

-LED flashes every 4 seconds one time in “Standard” mode and two times in “Speed” mode.

-LED intensity correspond to the battery status - if off or very low =>exchange the battery.

-LED is OFF if the Transmitter battery is discharged or in “Power Save” mode.

.

Reset to manufacturer default setting:

-Switch the module ON // insert battery.

-Press test button for min 10 seconds.

Note:

“GROUP” settings are not available for the EL-Skyport ECO Transmitter.

18