Hearth and Home Technologies PALOMA-GY, PALOMA-GR Loss of Power and Battery Backup Usage

	PLUG-IN 3V
	TRANSFORMER	FLAME
ON/OFF		SPARKER/SENSOR
WALL
SWITCH
	IGNITION
	MODULE
	(3V)
	VALVE	BATTERY
		PACK
		REMOTE
NEUTRAL	GROUND	CONTROL HOT

TRANSFORMER

3 VAC

PLUG IN

JUNCTION BOX

Figure 7.2

IGNITION MODULE

3 VAC

IINTERMITTENT PILOT IGNITOR

S

	WHT
BLACK	ORG
	GROUND TO
	APPLIANCE CHASSIS
RED	*
BRN	BRN
	ORG	GRN
PIGGYBACK
ON/OFF SWITCH

VALVE

NOTE: Appliance will not operate unless properly grounded.

CAUTION

Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING

Shock hazard.

•Replace damaged wire with type 105º C rated wire.

•Wire must have high temperature insulation.

D. Loss of Power and Battery Backup Usage

1.	Disconnect the power supply.		Unplug when
2.	Remove the front door assembly and lower access
			using batteries
	panel.
3.	Place two "D" cell batteries into	the battery holder.
	(Figure 7.3)
4.	Turn on appliance and verify it is operational.
5.	Replace lower access panel and front door assembly.
	CAUTION
If IPI battery back-up is installed:
• Do not install batteries if the backup mode may not be used
	for extended time.
•	Batteries may leak.
•	Install batteries only when needed for power outage.
			BATTERY LOCATION
			Figure 7.3
		Heat & Glo • Paloma • 7031-220 Rev. P • 10/08		31