E. Top to Rear Vent Conversion
Note: When installing this appliance in a rear vent configura- tion with no vertical rise, a Snorkel Kit must be used.
Kit Contents: Top cover (no hole); Back panel (with hole).
Tools Required: Power drill; #2 Phillips bit; 5/32 in. (4 mm) Allen wrench; 5/8 in. (16 mm) open end wrench;
1.Remove the front door assembly by lifting it off of the
2.Remove the top plate with hole and discard. (Figure 8.8).
Figure 8.8
3.Remove and retain the Allen head screws that hold the solid back panel in place. (Figure 8.9) Remove and discard the solid back panel.
PILOT ASSEMBLY
Figure 8.9
4.Remove the four screws from the DV adapter collar. (Figure 8.10) Set aside DV adapter collar and screws.
5.Remove the inner extension starter collar (Shown in Figure 8.10) and set aside.
INNER EXTENSION COLLAR
DV ADAPTER
Figure 8.10
6.Remove the four screws from the cover plate on rear of appliance. Retain screws. (see Figure 8.11).
Figure 8.11
7.Install the outer collar with gasket to the rear of appli- ance with screws previously removed. Install the inner extension starter collar. (Figure 8.12).
8.Install the new back panel (with hole) to the rear of appliance. Replace the allen head screws removed in Step 3 to hold the back panel in place. (Figure 8.12).
Figure 8.12
Heat & Glo • Paloma • | 35 |