Hearth and Home Technologies PALOMA-GY, PALOMA-GR, PALOMA-BL, PALOMA-BZ owner manual Black Wires

Disconnect all electrical power. Remove the front door assembly by lifting off of appliance. Remove the lower access door. See Figure 8.23.

Locate the machine screw underneath the firebox on the right side. Position the temperature sensor switch/bracket assembly over the machine screw and attach with the wing nut. Finger tighten. See Figure 8.26.

Figure 8.23

Attach enclosed wires to the temperature sensor switch/ bracket assembly. The blue wire attaches to the rear of the bracket and one of the black wires from the variable speed control attaches closest to the prepunched screw hole. See Figure 8.24.

Black Wires Blue Wires

Figure 8.24

Feed the blue wire and other black wire from the variable speed control behind the gas valve assembly. Insert the wires into the slots indicated.

FAN OUTLET

CLIP

VARIABLE SPEED CONTROL

&TEMPERATURE SENSOR SWITCH WIRES GO HERE

Figure 8.25

Figure 8.26

Note: The switch/bracket assembly must be installed so that the sensor switch makes contact with the bottom of the firebox.

Attach rheostat in mating feature of control shield so that orientation of control knob is downward. See Figure 8.27.

Figure 8.27

Heat & Glo • Paloma • 7031-220 Rev. P • 10/08 39