Monogram embrodiery
1.Sew and fill in the monogram along the script using a slow and smooth movement of the frame.
2.Secure the monogram by sewing a few straight stitches at the end of the last letter, remove the material from the machine in the usual manner.
Motive embroidery
1.First sew the outline of the motive, moving the embroidery frame accordingly.
2.Fill in the motive from the contour to the inside then back to the outside, until the contour has been completely filled in or embroide- red. Place the stitches very closely together.
Notice
A long stitch is created by moving the frame more quickly, a shorter stitch by moving the frame more slowly.
3.When you have finished, secure the work by sewing a few straight stitches.
Changing the lamp bulb
Important
Remove the power plug k from the wall socket! Danger of electric shock.
1.Loosen the screw of the front cover h using the screwdriver Y as illustrated.
2.Remove the front cover h from the machine.
3.Exchange the bulb of the sewing machine lighting.
4.Replace the front cover h and tighten the retaining screw.
2.Apply 2 to 3 drops of sewing machine oil K to all points indicated in the diagram.
3.Replace the front cover h and insert the power plug k into the wall socket.
4.After lubrication, start the machine up in rapid operation, without the needles being threaded, for a short period to distribute the oil.
5.Remove the power plug k from the wall socket and remove the front cover h.
6.Wipe off any superfluous oil.
7.Replace the front cover h and tighten the screw.
Notice
The machine should be lubricated once a week if it is being used for more than one hour a day. Lubricate the machine daily when it is used more frequently.
Lubricating the machine
Important
Remove the power plug k from the wall socket! Danger of electric shock.
1.Loosen the screw from the front cover h and remove the front cover h.
Cleaning
Dismantling of the gripper
1.Bring the needle into the highest possible position or, preferentially, dismantle the needle.
2.Open the flap on the sewing table.
3.Remove the bobbin case by the opening its flap and then pulling the bobbin case carrier from the bobbin case carrier pin.
4.Press the two catches i from the rear retainer u in an outward direction and then remove the released retainer u.
- 15 -