Bradford-White Corp CX), PDX75S70F(B, C)*(N Blower removal, Blower Installation, Remove exhaust

Pin location holes in

jacket head

Locating Pins on blower flange

Vertical air intake

Vertical air intake

bracket

PDX Series

PDX SERVICE PROCEDURE IV

Blower Testing and Replacement

Blower removal

Step 1. Position gas control power switch to the “OFF” position. Step 2. Unplug blower power cord from wall outlet.

Step 3. Disconnect vent system from exhaust adapter on top of blower.

Step 4. Remove exhaust adapter from blower (blade screw driver) and retain for use on new blower

Step 5. Unplug cord sets from blower. Step 6. Remove vertical air intake bracket.

Step 7. Disconnect vertical air intake from blower.

Step 8. Remove the three blower mounting screws (¼" nut driver).

Step 9. Remove blower with gasket from water heater.

Remove exhaust

adapter and retain for use on new blower.

Blower

Cord Sets

Blower Mounting

Screws

Blower Installation

Step 10. Clean any debris from jacket head of water heater.

Step 11. Set new blower with gasket in place using locating pins on blower flange to line up with location holes in jacket head. Be sure not to damage gasket.

Step 12. Secure blower in place using mounting screws from step 8. Step 13. Slide vertical air intake tee onto blower.

Step 14. Re-install vertical air intake bracket. Step 15. Re-install exhaust adapter from step 4.

Step 16. Reconnect vent system to exhaust adapter. Step 17. Reconnect cord sets from step 5.

Step 18. Plug blower power cord into wall outlet.

Step 19. Position gas control power switch to the “ON” position. Step 20. Verify proper blower operation.

Page 22

22