KitchenAid W10284348A Make Gas Connection, Complete Connection, Closed valve Open valve

3.Pull tube to ensure it is secured.

Water supply tubing to range

Sink

Water supply connection

Yellow

WATER

IN

	Water supply tubing	Blue
Shutoff	to cold water supply	WATER
valve		OUT
		Filter

4.Route flexible codes approved water supply line through undersink cabinet and oven cabinet cutout.

5.Connect the flexible codes approved water supply line to the range copper tubing, using a ¼" to ¼" water supply union.

B		F
	C	D
	A

E

A. To home water supply B. Rear of cabinet cutout

C. Flexible codes approved water supply line from home water supply

D. ¼" to ¼" water supply union (supplied in water filter kit) E. Oven copper tubing

F. Range front

6.Turn on water supply.

7.Check all connections for leaks.

NOTE: No flushing or conditioning of the water filter is required prior to use.

Make Gas Connection

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

1.Assemble flexible connector from gas supply pipe to pressure regulator located in the middle rear of the range.

2.Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexible connector adapters (see B and G in the following illustration).

3.Attach one adapter to the gas pressure regulator and the other adapter to the gas shutoff valve. Tighten both adapters.

4.Use a ¹⁵⁄₁₆" combination wrench and channel lock pliers to attach the flexible connector to the adapters. Check that connector is not kinked.

A B C

D

E

	H G	F
A. Gas pressure regulator	E. Manual gas shutoff valve
B. Use pipe-joint compound.	F. ½" or ¾" gas pipe
C. Adapter (must have ½" male	G. Use pipe-joint compound.
pipe thread)	H. Adapter
D. Flexible connector

Complete Connection

1.Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.

A

B

A. Closed valve

B. Open valve

15