Initial Lighting and Gas Flame Adjustments
Cooktop burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to any position, the system creates a spark to light the burner. This sparking continues, until the flame is lit or the knob is turned to Off.
Check Operation of Cooktop Burners
Push in and turn each control knob to the “LITE” position.
The surface burners and grill flames should light within
4 seconds. The first time a burner is lit it may take longer than 4 seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the control knobs to OFF.
If burners do not light properly:
■Turn cooktop control knob to the “OFF” position.
■Check that the range is plugged in and the circuit breaker has not tripped or the fuse has not blown.
■Check that the gas shutoff valves are set to the “open” position.
■Check that burner caps are properly positioned on burner bases.
Repeat
Flame Height
The cooktop flame should be a steady blue flame approximately ¼" (0.64 cm) high.
Dual Flame Burner
A
B
A. Upper flame
B. Lower (simmer) flame
Single Flame Burner
4.Open the oven door and remove the 2 screws on each side of the range that hold the control console in place.
NOTE: Make sure to leave oven door ajar or the control console will not rest in the side brackets properly once it is detached.
5.Pull up on the control console and let it drop forward into the notched console brackets on each side.
A
A. Control console bracket
6.Remove the round gasket from the valve stem.
7.Put a control knob onto the valve stem of the burner you want to adjust.
8. Using a butane extension lighter, turn the control knob to LO and light the burner.
To Adjust Flame Height:
1. Unplug range or disconnect power.
2.Remove burner grates.
3.Remove the control knobs.
9. Remove the control knob.
18