10.Use a ¹⁄₈" x 4¼"
NOTE: When you are converting to LP gas, the screw should be tightened down completely.
AB
A. Single flame burner adjustment screw (on right side of valve) B. Dual flame burner adjustment screw (on left side of valve)
11.When finished adjusting the flame height, put a control knob back onto the valve stem and turn off the burner.
12.Remove the control knob.
13.Replace the round gasket.
14.Repeat steps 6 through 13 for any other burners that need adjustment.
15.Lift up on the control console and set it back into place. For a proper fit, the flange of the control console must hook over the lip on the front of the range cooktop.
A
B
A. Control console flange
B. Front lip of range cooktop
16.Check that the control console is flush with the top edge of the range.
A
A. Flush with range top
17.Replace the 2 screws on each side of the control console.
18.Replace the control knobs.
19.Replace burner grates.
20.Test the flame by turning the control from LO to HI, checking the flame at each setting.
Reinstall Kickplate
1.Align shoulder screw mounting holes with shoulder screws on range.
2.Push kickplate up against front of range until the top screw holes are aligned with the mounting holes on the front of the range.
3.Reattach screws to the top of the kickplate.
B
C
A
D 
A.Kickplate
B.Reattach these screws.
C.Top screw hole
D.Shoulder screw mounting hole
Complete Installation
1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
2.Check that you have all of your tools.
3.Dispose of/recycle all packaging materials.
4.For oven use and cleaning, read the Use and Care Guide.
Check Operation of Oven(s)
1.Turn power on.
2.Start a Bake cycle. See the Use and Care Guide for operating instructions.
If oven(s) does not operate, check the following:
■Household fuse is intact and tight; or circuit breaker has not tripped.
■Electrical supply is connected.
■See “Troubleshooting” section in the Use and Care Guide.
3.When oven has been on for
If you do not feel heat or if an error code (“F” followed by a number plus “E” followed by a number) appears in the display, turn off the oven and contact a qualified technician.
4.Touch OFF.
To set the clock and other oven functions, refer to the Use and Care Guide.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your range.
19