Switch release | Charging or operation |
button (2) pressed | conditions |
down |
|
|
|
Green | Battery is fully charged |
|
|
Red/green flashing | Charge sufficient for at |
| least one usage |
|
|
Red | Battery is discharged |
|
|
Red | Overheating protection |
| active (go to Safety |
| features Α Overheat |
| protection) |
|
|
Safety features
Switching on the appliance / Switch lock
The appliance has a switch lock. To safely switch it on, follow these points:
1First press the switch release button (2) with your thumb and hold.
2Then press the On switch (3). During operation, you can stop pressing the switch release button.
•If the On switch (3) is not pressed within
5 seconds, the appliance cannot be switched on. The pilot light goes off.
•In order to switch the appliance on, start again with step 1.
Overheat protection
When the overheat protection feature is active, the appliance turns off and the pilot light shines permanently red.
Reason | Trouble shooting |
|
|
Blade is blocked | 1. Remove motor part |
| 2. Remove the food/ |
| blockage |
| 3. Place the motor part |
| into the charging unit |
| (connected to the mains) |
| for at least 1 second |
| 4. Processing can be |
| continued |
|
|
Appliance is | Follow points |
overheated | If the pilot light still shines |
| red when switching on the |
| appliance, place the motor |
| part back into the charging |
| unit and let it cool down |
| for ca. 1 hour. During this |
| time, the pilot light flashes |
| green. |
|
|
Auto Off
For safety reasons the appliance turns off after
4 minutes of permanent usage. The appliance can be turned directly on again.
Using your handblender
The handblender is perfectly suited for preparing dips, sauces, soups, mayonnaise and baby food as well as for mixing drinks and milkshakes.
a)Remove knife protection at the bottom of the blender shaft by removing the adhesive tape. Insert the motor part (4) into the blender shaft (6) until it locks.
b)Introduce the handblender vertically into the vessel, keep the switch release (2) pressed down, then press the On switch (3).
c)To remove the blender shaft from the motor part, press push buttons (5).
When operating the handblender in hot liquids do not immerse the blender shaft into – or remove it from the liquid while the appliance is switched on.
Recipe example: Mayonnaise200–250 ml oil,
1 egg (yolk and white),
1 tbsp. lemon juice or vinegar, salt and pepper to taste
Put all ingredients into the beaker according to the a.m. order. Introduce the handblender to the base of the beaker. After switching on, keep the handblender in this position until the oil emulsifies. Then, without switching off, slowly move it up and down until the mayonnaise is well combined.
Using your chopper attachment
The chopper is perfectly suited for chopping meat, cheese, onions, herbs, garlic, carrots, walnuts, almonds, prunes etc.
N.B.: Do not chop extremely hard food, such as nutmeg, coffee beans and grains.
Before chopping ...
•
•remove stalks from herbs,
•remove bones, tendons and gristle from meet.
10