Petsafe 400-1255-19 manuel dutilisation Understanding the Drinkwell Parts

UNDERSTANDING THE DRINKWELL®

PARTS

1)Housing Cover: the cover or lid snaps in place over the filter housing well, keeping pets out of the charcoal filter.

2)Housing: here the water is pumped up through the housing to cycle through the charcoal filter and out the spout to create a long five-inch waterfall into the bowl.

3)Pre-filter: a small intake grate that will catch large particles such as hair and kibble before they reach the filter. The pre-filter can be removed by pulling up on the lip at the top. To replace, slide back into place over the flow control knob and push down until it clamps around the knob.

4)Bowl: the Drinkwell® bowl is the foundation of the fountain. It features two handles on either side of the fountain as well as a “cord channel” to hide the cord from view.

5)Flow Control Knob: the black knob that attaches to the motor which will adjust the rate of water flow. The pre- filter will snap around the neck of the flow control knob which will lock it into place. The knob is attached to the motor and can be removed by taking the motor apart (See section “Motor Maintenance”).

6)Motor or Pump: a small submersible aquarium pump that can be dismantled for cleaning. THE PUMP IS NOT DISHWASHER SAFE! Remove pump from fountain before cleaning (See “Motor Maintenance”) The pump cord also features a removable inline plug for easy attachment.

7)Reservoir: the extra capacity reservoir holds over a half gallon of water. The reservoir cap will help to minimize spills when you refill the reservoir.

www.petsafe.net13