GE PGP989 Unpacking Your Cooktop, Parts Included Packed below the Cooktop, Burner Grate Regulator

Installation Instructions

UNPACKING YOUR COOKTOP

PARTS INCLUDED (PACKED BELOW THE COOKTOP)

•	Blower assembly	•	Vent grille gasket	•	Burner caps
•	Blower plenum	•	Cleaning cream		(1 small, 2 medium, 1 large)
• (4) Nuts (10-32 keps – nuts with		• Scrub sponge or scraper		• Gas pressure regulator &
	lock washers attached)	•	(on some models)	•	LP Conversion Instructions
• (9) Sheet metal screws			Burner grates		Attached 120-volt grounded
	(8-18 x 3/8″ )	•	Burner heads	•	plug cord
• Foam gasket tape (9-ft. roll)			(1 small (A), 2 medium (B),		Reflective tape
•	Vent grille		1 large (C))

•Vent filter

Check to be sure that all packing materials and tape have been removed. This will include tape on control knobs (if applicable), adhesive tape, wire ties, cardboard and protective plastic. Failure to remove these materials could result in damage to the appliance once the appliance has been turned on and surfaces have heated.

Reflective Tape

Cleaning Cream

Scrub Sponge

Sheet Metal Screws (9)

(8-18 x 3/8″ )

CAUTION:

Burner Grate (2)	Regulator	Vent Grille
	Burner Caps and Burner Heads

CAUTION:

GLASS IS FRAGILE

DO NOT BUMP EDGE

OF GLASS DURING

INSTALLATION

DO NOT LIFT

FROM VENT

OPENING OR

BUMP GLASS

Burner Cap and Burner Head

Burner Cap and Burner Head

Blower Assembly and (4) Mounting	Foam Gasket Tape	Vent Grille Gasket
Nuts (10-32 keps – nuts with lock			Vent Filter
		Blower Plenum
washers attached)
		16