GE PGP989 manual Do not allow anyone to climb, stand or hang on the cooktop, Ge.com

Page 3

ge.com

IMPORTANT SAFETY NOTICE

The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the state to cause cancer, birth defects or other reproductive harm, and requires businesses to warn customers of potential exposure to such substances.

Gas appliances can cause minor exposure to four of these substances, namely benzene, carbon monoxide, formaldehyde and soot, caused primarily by the incomplete combustion of natural gas or LP fuels. Properly adjusted burners, indicated by a bluish rather than a yellow flame, will minimize incomplete combustion. Exposure to these substances can be minimized by venting with an open window or using a ventilation fan or hood.

SAFETY PRECAUTIONS

Have the installer show you the location of the cooktop gas shut-off valve and how to shut it off if necessary.

Safety Instructions Operating Instructions

Have your cooktop installed and properly grounded by a qualified installer, in accordance with the Installation Instructions. Any adjustment and service should be performed only by qualified gas cooktop installers or service technicians.

Do not attempt to repair or replace any part of your cooktop unless it is specifically recommended in this manual. All other service should be referred to a qualified technician.

Locate the cooktop out of kitchen traffic path and out of drafty locations to prevent poor burner performance.

Plug your cooktop into a 120-volt grounded outlet only. Do not remove the round grounding prong from the plug.

If in doubt about the grounding of the home electrical system, it is your personal responsibility and obligation to have an ungrounded outlet replaced with a properly grounded, three-prong outlet in accordance with the National Electrical Code. Do not use an extension cord with this appliance.

Let the burner grates and other surfaces cool before touching them or leaving them where children can reach them.

Be sure all packaging materials are removed from the cooktop before operating it to prevent fire or smoke damage should the packaging material ignite.

Be sure your cooktop is correctly adjusted by a qualified service technician or installer for the type of gas (natural or LP) which

is to be used. Your cooktop can be converted for use with either type of gas. See the Installation Instructions in the LP Conversion Kit.

WARNING:These adjustments must be made by a qualified service technician in accordance with the manufacturer’s instructions and all codes and requirements of the authority having jurisdiction. Failure to follow these instructions could result in serious injury or property damage. The qualified agency performing this work assumes responsibility for the conversion.

Do not leave children alone or unattended where a cooktop is hot or in operation. They could be seriously burned.

Do not allow anyone to climb, stand or hang on the cooktop.

Do not operate or clean your cooktop if the glass is broken or cracked. Cleaning solutions and spillovers could penetrate the broken cooktop and create a risk of electric shock. Call for service immediately if the cooktop glass breaks or cracks.

Care and Cleaning Troubleshooting Tips Consumer Support

3

Image 3
Contents Write the model and serial numbers here Model # Serial # Consumer Support49-80516 07-08 JR ProductWhat to do if YOU Smell GAS Ge.com Do not allow anyone to climb, stand or hang on the cooktopSafety Precautions Glass Cooktop Surface on some models Clean the cooktop surface with cautionSurface Burners Operating Instructions Care Cleaning Troubleshooting Tips Consumer SupportFeature Index Explained Features of your cooktopConsumer Support Using the gas surface burnersSafety CleaningInstructions Using your cooktopUsing the downdraft vent system Troubleshooting TipsBurner Caps, Heads and Electrodes Care and cleaning of the cooktopHow to Remove Protective Shipping Film and Packaging Tape Sealed Burner AssembliesVent Filter and Chamber Cleaning Operating Instructions SafetyTroubleshooting Tips Care Burner Grates, Vent Grille and GasketStainless Steel Surfaces on some models Cleaning the glass cooktopNormal Daily Use Cleaning Control KnobsHeavy, Burned-On Residue Support TroubleshootingTips ConsumerCommonwealth of Massachusetts For Your SafetyImportant Safety Instructions Before YOU BeginBurner Grate Regulator Unpacking Your CooktopParts Included Packed below the Cooktop Sheet metal screws Burner grates30″ Cooktop Dimensions for Reference only PreparationTools and Materials YOU will Need Preparing for Installation Cabinet PreparationPreparing the Base Cabinet Blower to Ductwork Alignment Cabinet Preparation CutoutsPreparing the Countertop Preparing for DuctworkDuctwork Calculations Calculate Total Equivalent Ductwork LengthDo not use flexible plastic ducting Air Exhaust Blower Ratings Exhaust Blower Safety WarningDowndraft Cooktop Exhaust Blower CFM Flow CFMDuctwork Installation Installing the DuctworkOptional Installation Rear Wall Venting AN OLD Previously Used Line Power Supply LocationsGAS Supply Electrical SupplyUnpacking the COOKTOP/INSTALLING the Gasket Do not Bump Edge of Glass During InstallationDo not scratch the glass while cutting the foam gasket tape Checking for Flatness Installing the CooktopInstalling the Cooktop Installing the Optional Installation BracketsInstalling the Blower to the Plenum Installing the Blower Plenum to the CooktopPerform leak test per the following instructions Connecting the DuctworkAttaching a Blower Transition Duct Test for LeaksBlower Electrical Connections Blower Electrical ConnectionsTemporary Method Electrical ConnectionsElectrical Requirements Preferred MethodDo not operate the vent without the filter in place Final AssemblyAssemble BURNERS, Check Ignition Check for proper ignitionBurners do not light Plug on cooktop is not Before you call for service…Yellow tipping on outer cones is normal Yellow flames Yellow tipsOr obstruction Check exterior wall cap damper door for free movementPlease place in envelope and mail to GE Service Protection PlusConsumer Product Ownership Registration What GE Will Not Cover GE Gas Cooktop WarrantyCare and Cleaning GE Will ReplaceReal Life Design Studio Schedule ServiceParts and Accessories Consumer Support GE Appliances WebsiteEscriba el número de modelo y de serie aquí Modelo # Serie # Solución de averías . . . . . . . . . . . . . . .31Solución e identificación Instrucciones de OperaciónAviso Importante DE Seguridad Tela Instrucciones de Operación LimpiezaCuidado y Solución e identificación de averíasUnidades DE Superficie Radiante en algunos modelos 6explotar Quemadores DE SuperficieGuarde Estas Instrucciones Instrucciones de Seguridad Características de su estufaSeguridad Instrucciones Cómo usar los quemadores de superficie de gasInstrucciones Seguridad Apoyo al consumidorSartenes Tapas, Cabezas y Electrodos de Quemadores Cuidado y limpieza de la estufaApoyo Ensambladuras del quemador selladoInstrucciones Seguridad Instrucciones de Operación Cámara y filtro de ventilaciónReemplazo Centro de partes nacional Ge.com Botones de controlSuperficies de Acero Inoxidable en algunos modelos Limpieza de uso normal diarioDe cerámica Para ordenar partesCentro de partes nacional El limpiador de estufasPOR SU Seguridad Antes DE ComenzarPuede producir como resultado un daño sobre Desempacando SU EstufaPartes Incluidas Empacadas Debajo DE LA Estufa Protector. Si estos materiales no se retiran seLa unidad se muestra totalmente ensamblada PreparaciónHerramientas QUE Necesitará Para conexiones rígidasPreparando un gabinete tipo península o tipo isla Preparación DEL GabinetePreparación DEL Gabinete DE LA Base Preparando un gabinete que ajuste contra la paredNo exceda la adaptación máxima recomendada de 6″ Cortes DE Preparación DEL GabinetePreparando LA Encimera NotaNo USE conductos de plástico flexibles Cálculos DE LOS ConductosCalcule la longitud de conducto equivalente total ImportanteLongitud de conducto equivalente a un diámetro de Rangos DEL Soplador DE Escape250 FlujoCómo Instalar LOS Conductos Instalación DE LOS ConductosUNA Línea Usada Anteriormente Localización DEL Suministro EléctricoSuministro DE GAS Suministro EléctricoCómo Instalar LA Junta DE Espuma Y Cinta Reflectante Cómo Desempacar LA Estufa / Instalar LA JuntaCómo Inspeccionar LO Plano Cómo Instalar LA EstufaPrecaución Cómo Instalar LA Estufa11 Cómo Instalar LA Cámara DEL Soplador DE LA Estufa 12 Cómo Instalar LA Cámara DEL Soplador13 Cómo Pegar UNA Transición DE Soplador 14 Cómo Conectar LOS ConductosInstalación DEL Regulador DE Presión Conexiones Eléctricas DEL Soplador Prueba DE FugasMétodo preferido Conexiones EléctricasRequisitos Eléctricos Precauciones Sobre EL USO DE Cables DE ExtensiónNo opere la ventilación si el filtro en su lugar Ensamblaje FinalEnsambladura DE LOS QUEMADORES, Inspeccione LA Ignición Inspeccione la igniciónAntes de llamar para solicitar servicio… Instrucciones de Seguridad Operación Notas De averías Un año Garantía de GE para su estufa a gasGE reemplazará Lo que no está cubierto por GEPiezas y accesorios Apoyo al consumidor Página Web de GE AppliancesSolicite una reparación Garantías ampliadas
Related manuals
Manual 8 pages 47.47 Kb