Aiwa LCX-350 manual Basic Recording, Inserting Blank Spaces, Press the @ button to start recording

BASIC RECORDING

6 —. —. ?

Preparation

●Set the tape to the point where recording will start.

●Only Type I (normal) tapes can be recorded.

1Insert the tape to be recorded on into the deck.

Insert the tape with the side to be recorded on first facing out from the unit and the exposed side down.

2Press theTAPE button to select the reverse mode.

To record on one side only, select 1.

To record on both sides, select =) or (1).

3 Press one of the function buttons and prepare the source to be recorded.

To record from a CD, press the CD button and load the disc. To record from a radio broadcast, press the TUNER button

and tune in to a station.

To record from the connected source, press the AUX button

and prepare to play.

4 Press the @ button to start recording.

m

When the selected function is CD, playback and recording start simultaneously.

When the selected function is AUX, start playback on the connected equipment.

To stop recording, press the 9 button.

To pause recording, press the 11 button. (Applicable when the source is TUNER or AUX.) To resume recording, press again.

To start recording with the remote control

First press the ~ button, and then press the > button within 2 seconds.

m

Recording cannot be done when the TAPE function is selected.

INSERTING BLANK SPACES

Insertion of 4-second blank s~aces may help you to locate the begining of the track on other equipmeht. (Applicable when the source is TUNER or AUX.)

1 Press the O button during recording or while in recording

pause	mode.
~flashes		for 4 seconds and the tape	runs without
recording, After 4 seconds, the deck enters the recording
pause	mode.
2 Press the II		button to resume recording.	[m

To insert a blank space of less than 4 seconds, press the @

button again while w is flashing.

To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press the ● button again. Each time the button is pressed, a 4-second blank space is added

To erase a recording

1Insert the tape to be erased into the deck.

2Set the tape to the point where the erasure is to be started.

3Set the reverse mode by pressing the TAPE button.

4Press the AUX button.

If an optional equipment is connected to the AUX jacks, turn it off.

5Press the ● button to start the erasure.

ENGLISH 12