Shindaiwa 62891-94311 manual Safety Equipment and Labels

Page 5

Operating Precautions (continued)

■ Always maintain the P231 pole

CAUTION!

■ Always clear your work area of trash

■ Do not make unauthorized

pruner according to the this owner’s

modifications or substitutions to the

or hidden debris to help ensure

manual and follow the recommended

guide bar or chain.

good footing.

scheduled maintenance.

■ Never allow the engine to run at high

■ Keep the saw chain sharp and

■ Never modify or disable any of the

RPM without a load. Doing so could

properly adjusted.

pole pruner’s safety devices.

damage the engine.

■ Keep the pruner as clean as

■ Always use genuine Shindaiwa parts

■ When transporting the pruner in

possible. Keep it free of loose

and accessories when repairing or

a vehicle, tie it down securely to

vegetation, mud, etc.

maintaining this unit.

prevent damage and fuel spillage.

 

 

 

 

Safety Equipment and Labels

IMPORTANT!

Safety and Operation Information Labels: Make sure all information labels are undam- aged and readable. Immediately replace damaged or missing information labels. New labels are available from your local autho- rized Shindaiwa dealer.

Page 4 Page 6
Image 5
Page 4 Page 6
Contents P231 Pole Pruner Introduction ContentsKickback and Pinching Safety PrecautionsBeware of Kickback Beware of pinchingProperly Equipped Operator Operating PrecautionsOperating Precautions Safety Equipment and Labels Product Description Technical SpecificationsPrior to assembly AssemblyPowerhead Installation Connecting the Throttle CableKeep the open ends of the tubes clean and free of debris Adjusting the Throttle CableConnect The Throttle Cable Assembling tube sectionsDisassembling the tube sections Installing and Adjusting the Bar and ChainInstalling the Chain Adjusting Oil Flow Rate Adjusting the ChainAdjust the pump as follows Chain OilerFilling the Fuel Tank Mixing FuelMinimize the risk of fire, burns, and personal injury Always transport and store fuels in an approved containerNever start the engine from the operating position When the Engine StartsStarting the Engine Stopping the Engine Adjusting the Engine IdleCheck and Adjust Idle Speed Using the Pole Pruner Daily Maintenance General MaintenanceHour Maintenance MufflerEvery 10 to 15 hours of operation 10/15-Hour MaintenanceClean or replace fuel filter Muffler maintenance MaintenanceEvery 135 hours of operation, remove and clean the muffler Long Term StorageFor consistent filing angles, use a filing guide Sharpening the ChainWhat To Check Troubleshooting GuideSymptom Possible Cause Emission System Warranty Statement Fax Specifications subject to change without notice P231 Podadora de Extensión Índice Introducción Declaraciones de seguridadTrabaje con cuidado Instrucciones generales de seguridad¡ADVERTENCIA! Contragolpe y apriete Guardarte de contragolpePrecauciones del funcionamiento El operario debidamente equipadoInstrucciones de seguridad Realice siempre el mantenimiento Instrucciones de seguridad continuaciónEtiquetas de seguridad Especificaciones Descripción del productoAntes de Ensamblar EnsamblarBarras y cadenas opcionales Conexión del cable del aceleradorConecte el cable del acelerador Ensamblar continuaciónAjuste el cable del acelerador Ensamblar de las secciones del tuboInstalación la cadena Instalación y ajuste de la barra y la cadena de la sierraDesmontaje de las secciones del tubo Bomba de aceite Adjuste la cadenaLlenado del depósito de aceite Ajuste del flujo del aceiteLlenando el tanque de combustible Mezcla de combustibleEjemplos de cantidades de mezcla a proporción de ¡ADVERTENCIA! Disminuya el riesgo de incendiosCuando arranca el motor… Arranque del motorNunca arranque el motor desde la posición de operación Ajuste de marcha mínima del motor Parada del motorEl accesorio de cortes pudo Continuar girando cuando se para El motorEl uso de la potadora de extensión Cada 10 horas mantenimiento Mantenimiento generalMantenimiento diario Cada 50 horas mantenimiento Mantenimiento continuaciónCada 10 15 horas mantenimiento Cada 135 horas de operación, retire y limpie el silenciador Almacenamiento de largo plazoMantenimiento del silenciador Guía para la lima Rendimiento de la cadenaPara limar en ángulos iguales, use una Qué revisar Guía de localización de fallasPosible causa RemedioQué revisar Posible causa Remedio Guía de localización de fallas continuaciónDeclaración de Garantía del Sistema de Emisión Notas Tronçonneuse à perche P231 Unénoncéprécédédelamention Introduction Mises en gardeLes échappements du moteur De ce produit contiennent des subRéaliser les coupes à haut régime Consignes de sécuritéNe pas utiliser l’appareil sans le silencieux Équipement complet de l’utilisateurConsignes d’utilisation Étiquettes et dispositifs de sécurité Consignes d’utilisation suiteCaractéristiques techniques NomenclatureMontage de la tête motorisée Avant l’assemblageOptions du guide-chaîne et de la chaîne Raccord du câble d’accélérationRaccorder le câble d’accélération Assemblage suiteRéglage du câble d’accélération Assemblage les éléments du tubeDésassemblage des éléments Installation et réglage du guide-chaîne et de la chaîneInstallation de la chaîne Huileur de chaîne Réglage de la chaîneRemplissage du réservoir d’huile Réglage du débit d’huileRemplissage du réservoir de carburant Mélange de carburantLorsque le moteur démarre Démarrage du moteurVérification et réglage du ré- gime de ralenti Arrêt du moteurRéglage du ralenti du moteur Utilisation de la tronçonneuse Entretien quotidien EntretienEntretien aux 10 heures SilencieuxRemisage à long terme Entretien suiteEntretien aux 10 à 15 heures Entretien aux 50 heuresEnlever le capuchon de la bougie Entretien du pare-étincellesTechnique d’affûtage correcte Affûtage de la chaînePoints à contrôler Cause probable Solution SolutionGuide de dépannage Points à contrôlerCause probable Guide de dépannage suiteDéclaration de garantie du dispositif antipollution FR22 FR23 FR24

62891-94311 specifications

The Shindaiwa 62891-94311 is a premium combination of engineering and technology, designed for lawn care and landscaping professionals. This tool provides efficient and reliable performance, making it a top choice for outdoor enthusiasts and contractors alike. One of the standout features of the Shindaiwa 62891-94311 is its lightweight yet durable construction. This ensures that it delivers high performance without sacrificing user comfort, allowing operators to work for extended periods without undue fatigue.

This model is equipped with advanced engine technology that enhances fuel efficiency and reduces emissions. The 2-stroke engine not only delivers impressive power but also adheres to stringent environmental regulations. Users appreciate the reduced environmental footprint, which aligns with a growing trend towards sustainability in landscaping equipment.

Another key characteristic of the Shindaiwa 62891-94311 is its ergonomic design. The handle is designed for optimum comfort and control, reducing vibration during use, which leads to greater precision and reduces the risk of strain injuries. The combination of the lightweight structure and ergonomic grip allows for longer operational hours, ensuring that users can tackle large projects efficiently.

The product features easy-start technology, enabling quick and effortless ignition. This is particularly beneficial for professionals who need to maximize productivity on job sites. Additionally, the model includes an adjustable throttle, allowing users to easily adapt the power output according to their specific needs, whether it’s for trimming, edging, or heavy-duty cutting tasks.

Durability is another focus for the Shindaiwa 62891-94311. The materials used in its construction are engineered to withstand the rigors of outdoor use, ensuring longevity and reliability. This means that users can invest in this tool with confidence, knowing it can handle extensive workloads and still perform optimally.

In conclusion, the Shindaiwa 62891-94311 is a versatile and powerful tool that incorporates advanced technology, ergonomic design, and durability. It is an ideal choice for landscaping professionals seeking a reliable, efficient, and eco-friendly solution for their outdoor tasks. Whether trimming hedges or tackling tough underbrush, this model stands out as a preferred option in the field of outdoor power equipment.
Top Page Image Contents