Samsung SCC-C6475P Chapter 2 SCC-C6475(P) Installation, Factory Default, Caution

Factory Default

It recovers the whole setting of SCC-C6475(P) to the factory default. There are two Factory Default methods as follows.

(1) Using the Factory Default in the Reset page

Refer to 5. Setting and changing the function (System - Reset) in Chapter 3 Network menu Overview.

(2)Using the Factory Default button on the side of the unit. Proceed as follows.

1.Turn the power off.

2.While pressing the Factory default button, turn the power on.

3.When the Status LED flickers 3 times in red, unpress the Factory Default button.

4.If the Status LED turns to green, the whole setting of SCC- C6475(P) recovers to the factory default.

Caution

After executing, the user can access only when executing the basic network setting (IP Address, Subnet<RS-485 Half Duplex configuration> Mask, Gateway) by using the IP installer.

Chapter 2 SCC-C6475(P)Installation

In this chapter, we will check the contents of the package before	E
installing the SCC-C6475(P), and prepare a power adapter suitable
for the power supply system.
(Power Consumption: 25W; Voltage: AC24V, 1.5A)
Then, we will install the SCC-C6475(P) and connect the cables.

1-13 2-1