Samsung SHR-6040P, SHR-6042P Profile, System Log, Caution, Yes, Enter, Enter, Search, Progress, setup menu, menu setup _23, Profile Export, Profile Import, Scope Designation

SearchThe “Playback” item allows granting the search right.

Profile

Profile

Load Factory Default		OK
Profile Export		OK
Profile Import		OK
Progress
	trying.. 0%
		OK
Move/Control	Select	Exit

Load Factory Default

This function is used when you reset all menu setting values to the factory default values.

If you press “OK”, the restart message window appears. You can select “Yes”. The recorded data will not be deleted.

Profile Export

Allows you to configure multiple DVR units with ease. This function is used when you export the profile currently set to the system to the storage device connected to a USB port. The profile file will be copied to the USB memory if you press “OK”. (Filename: SetupData.tar)

Profile Import

This function is used when you import the system profile file stored in a USB memory and apply to the current system. The profile file will be copied to the current system if you press “OK”. Then, the restart message window appears. You can select “Yes”.

Progress

This function will show the progress status of the job that the system is currently executing.

	 Please do not remove the USB memory
Caution	when you run the profile export/import
	function. The system profile file may
	not be copied properly or may not be
	applied to the system.
	 When the system profile file that is included
	the value for network setup applies for
	another DVR, an IP address conflict may
	occur due to the same address. If so,
	please reset the network configuration
	to avoid an IP address conflict.

System Log

System Log

04-02 06:08:09 C3 C REC Stop					REC
04-02	06:08:09 C3	M	REC	Start C3	System
04-02 06:08:47 C2 M REC Stop					Failure
04-02	06:08:47 C1	M	REC	Stop	Search
04-02	06:08:50 C4	M	REC	Stop	Network
04-02	06:08:50 C3	M	REC	Stop	Backup
	2007-04-02 05:39:53 ž 2007-04-03 05:39:53
					OK

This function shows a series of logged tasks made in operating the DVR system and when the system runs abnormally, it allows finding the error easily so that the problem can be fixed.

Press the Enter() button after moving the cursor on the desired log item.(): Move to the previous page.(): Move to the next page.Scope DesignationIf the ( ) icon is pressed, the following screen appears.

Start Time		2007		- 04	- 02	05	: 39	: 53
Year	Month		Day			Hour		Min	Sec
2007	4		2			5		39	53
End Time		2007		- 04	- 03	16	: 35	: 44
Year	Month		Day			Hour		Min	Sec
2007	4		3			16		35	44

OK

For the log data, set the “Start Time” and “End Time

”to be searched. To change the date and time, move the cursor to the corresponding item and press the

Enter() button. Then, change the day/month/year or second/minute/hour using the  or  buttons. Escape from the change mode by pressing the Enter () button again.

setup menu 05

menu setup _23