Samsung SHR-6040P, SHR-6042P Alarm Detection Setup, Enter, Enter, ALARM, Camera, If the, State, Camera, CONTINUE, Duration, Alarm Out, Post Event, 32_ menu setup, N.O (Normally Open)

Post Event

Time that an event has occurred

Post-Event Section

Camera

Sets the camera linked to the current Alarm In. The default value is set to the current Alarm In number. At least one link between Alarm In and camera has to be established. Multiple selections are possible.

The following screen will appear if the Enter() button is pressed by moving the cursor from the camera item.

Record the post-conditions from the point that an event has occurred.

After event occurring, sets recording time in 5 seconds ~5 minutes, and 1 hours.

If the 1-channel DVR support is set to On in the monitoring menu, the resolution is changed to Full D1.

Alarm Detection Setup

Alarm Detection Setup

Alarm In	State	Camera		Alarm-Out	Duration
Alarm In 1	N.O	1		None	10 SEC
Alarm In 2	N.O	2		None	10 SEC
Alarm In 3	N.O	3		None	10 SEC
Alarm In 4	N.O	4		None	10 SEC
				OK	Cancel
Move/Control			Select		Exit

StateThe Alarm In type can be set to “N.O” or “N.C”.

N.O (Normally Open): Sensor remains open. But if it gets closed, an alarm is issued.

N.C (Normally Closed): Sensor remains closed. But if it gets open, an alarm is issued.

Camera 1	Camera 2	Camera 3
Camera 4	All

OK Cancel

Alarm OutSets an alarm-out method when an event has occurred from the Alarm In.

Currently, this system supports 2 Alarm Out functions and 1 built-in speaker (beep) output.

The following screen will appear if the Enter() button is pressed by moving the cursor from the Alarm Out item.

1 2

Beep All

OK Cancel

Duration

Sets the duration for Alarm Out. The alarm sound will be maintained with the value set.

CONTINUE: The alarm output sound will be maintained until it is cancelled by pressing the ALARM button manually on the front panel.

10~300 Seconds: You can set the duration for the alarm output.

32_ menu setup