Samsung SHR-6040P, SHR-6042P Camera, Caution, Caution, Caution, System Shutdown, menu, Enter, place, HDD END, OverWrite, OverWrite, setup menu, HDD Format, ) icon appears

HDD FormatWhen initializing the HDD, move the cursor to the

corresponding HDD and press the Enter() button. Then, the (Format) icon is activated.

If you press “Format”, the HDD format window appears. You can select “OK” to initialize the HDD.

HDD ENDStop: Recording stops when the HDD becomes full while in recording.

OverWrite: If the HDD becomes full while in recording, the data recorded at the earliest time will be deleted and new data will be written.

HDD END ALARM ()On: If the HDD becomes full while in recording, it gives an alarm.Off: If the HDD becomes full while in recording, it does not give any alarm.If the HDD space is not enough, the Disk_Full

(	) icon appears.
	 Because all data will be deleted when
Caution	the HDD formatting is executed, please
	proceed with the initialization after
	backing up important data to other
	place.

If the repeated HDD recording is set to “ OverWrite” and the data to be backed up are overwritten, either the backup start time can be changed or the backup is cancelled.

Checking HDD Data

Caution Please, pay attention to Following information to minimize the chance of losing HDD data.

Remember that you should protect HDD from any impact or misuse as this may cause damaged.

The Manufacturer is not responsible for missing data or defects caused by the user’s mishandling.

Note: Adding Extra HDD.

Check in advance that the HDD is compatible with the manufacturer’s DVR.

Examples that can cause loss of data or damage HDD.

Any outside Impact on the case which could happen whilst disassembling or setting up the DVR.

Power cut or incorrect shutdown whilst the DVR is operating. (Refer to page 27: how to turn off DVR)

Moving or causing any impact on the DVR during operation.

Please, back up events as soon as possible to minimize disappointment should HDD data be lost.

System Shutdown

System Shutdown

Sure to shutdown?

	OK	Cancel
Move/Control	Select	Exit

This function is used when either terminating the running jobs safely or turning off the power.

If you see the system shutdown message after pressing “OK” on the confirmation window, turn off the power.

	 If the system is turned off without
Caution	terminating it using the system shutdown
	menu, it may cause a problem such as
	data loss and disk failure. When turning
	off the power, please terminate the
	system first using the system shutdown
	menu.

Camera

The details of the camera menu are as follows:

SHR-6042/6040 MENU

System	►
Camera	►	Camera Configuration
		PTZ Device
Monitoring	►
		Screen Setup
Record Mode
		Remote Control Device
Event Record	►
Record Schedule
Backup
Network	►
Move/Control		Select	Exit

menu setup _27

setup menu 05