3Com 155 PCI For Ethernet, 4542 for 4 Mbps, Value can interoperate, Rate 155, Available to an LEC

4-12 CHAPTER 4: NETWARE SERVER DRIVER INSTALLATION

Table 4-1 3C975 ATMLink NIC NetWare Install Utility Configuration Parameters (cont’d)

	Range of Values
Parameter	(Defaults in Bold)	Description
Maximum Frame Size	1514	All ELANs with the same card number
	4542	must have the same MFS value, also
	9232	called maximum transfer unit (MTU). Use
		1514 for Ethernet, 4542 for 4 Mbps
		token ring, and 9232 for 16 Mbps token
		ring. Only end stations using the same
		value can interoperate.
Rate	1–155	Sets the maximum bandwidth in Mbps
		available to an LEC.
LEC Configuration	Automatic	Select Automatic for ILMI service. Select
Mode	Manual	Manual to connect with a specific LECS
		or LES.
LECS Network Prefix	ATM Forum	Enter the 13-byte network prefix of the
	Well-known Address	switch on which the target LECS resides.
	(not shown)
LECS User Part	00A03E00000100	Enter the 7-byte user part of the target
	(not shown)	LECS address (the ESI plus 00 as the
		selector byte).
LES Network Prefix	No default	Enter the 13-byte network prefix of the
		switch on which the target LES resides.
LES User Part	No default	Enter the 7-byte user part of the target
		LES address (the ESI plus 00 as the
		selector byte).
Maximum VCCs	5–1024	There are 4,096 open VCCs supported
Allowed		per system (4 NICs per system).
VPI/VCI Range	0 bits/12 bits	This parameter is determined by the ATM
	1 bits/11 bits	switch setting and must be the same for
	2 bits/10 bits	all NICs in the system.
	8 bits/4 bits
ILMI VPI	0	This parameter is determined by the ATM
		switch setting.
ILMI VCI	16	This parameter is determined by the ATM
		switch setting.
Signaling Version	UNI v3.0	This parameter is determined by the ATM
	UNI v3.1	switch setting and must be the same for
		all NICs in the system.