3Com 155 PCI manual NetWare Keywords cont’d, Usage Rules Lecconfigmode, Lecsnp, Lecs network prefix

		Editing the AUTOEXEC.NCF File	4-25
Table 4-2 NetWare Keywords (cont’d)
	Range of Values
Keyword	(Default in Bold)	Usage Rules
lec_config_mode	1, 2	1=Automatic (uses ILMI or
(LEC configuration mode)		user-supplied LECS address)
		2=Manual (must supply address for
		LES or LECS when using this option)

lecs_np	Default is 13-byte
(LECS network prefix)	network portion of
	ATM Forum
	Well-known Address.

Use the 13-byte network prefix of the switch on which the target LECS resides.

lecs_up	00a03e00000100	Use the 7-byte user part of the 20-byte
(LECS user part)	is default	ATM address of the target LECS.
les _np	26-character ASCII	Use the 13-byte network prefix of the
(LES network prefix)	string	switch on which the target LES
	(13 hex digits)	resides.
les_up	14-character	Use the 7-byte user part of the
(LES user part)	ASCII string	20-byte ATM address of the target
	(7 hex digits)	LES.
maxvcc	1–1024	The default value is 1,024 VCCs. With
(maximum number of		four NICs, the maximum number of
virtual channel circuits)		open VCCs is 4,096.
vpivci	0, 1, 2, 3	0=0/12 bits (default)
(VPI/VCI range)		1=1/11 bits
		2=2/10 bits
		3=8/4 bits
		Be sure that the VPI/VCI range is the
		same for all installed NICs in the
		system.
ilmi_vpi	Depends on ATM	The default value is 0.
(VPI for ILMI)	switch settings
ilmi_vci	Depends on ATM	The default value is 16.
(VCI for ILMI)	switch settings
rate	1–155	Sets the maximum bandwidth in Mbps
		available to an LEC.
sig_version	0, 1	0=UNI v3.0
(signaling version)		1=UNI v3.1 (default)
		Make sure that all installed NICs in the
		system use the same signaling
		version.