3Com 155 PCI manual Select LAN/WAN Information from the Available Options menu, 4-21, load monitor

Verifying Driver Installation and Configuration 4-21

with card number 2, and the fourth ATMLink NIC found is recognized as a standby NIC. The first ATMLink NIC to flash during server initialization is card number 1, the next to flash is card number 3, and the last to flash is card number 2. The LEDs of standby NICs do not light up unless they become active NICs.

The direction in which the computer scans the PCI bus differs with the manufacturer.

load 3c975.lan cardnum=1 name=atm_1 elan=a (etc.) load 3c975.lan cardnum=3 name=atm_2 elan=b (etc.) load 3c975.lan cardnum=2 name=atm_3 elan=c (etc.) load 3c975.lan cardnum=2 name=atm_4 elan=d (etc.) load 3c975.lan cardnum=4 home=1,2,3 (etc.)

bind ipx atm_1 (etc.) bind ipx atm_2 (etc.) bind ipx atm_3 (etc.) bind ipx atm_4 (etc.)

CAUTION: The load order of the driver determines which physical NICs are bound to which drivers. Changing the sequence of load commands in the AUTOEXEC.NCF file may necessitate changing the cabling of the physical NICs.

Verifying Driver Installation and Configuration

Check server	To verify that the driver has been properly loaded on the
driver	NetWare server, perform the following procedures:
installation
1	At the system prompt, type:
	load monitor
	The NetWare Monitor screen appears.

2Select LAN/WAN Information from the Available Options menu.

The Available LAN Driver menu appears. If the 3C975.LAN driver is properly loaded, it appears on this menu.

3Select 3C975.LAN and view the displayed statistics.

A functioning driver displays packets being sent and received.