3Com 155 PCI manual Select the VPI/VCI range, Select Save parameters and load driver

Configuring LECs and Resilient Server Links 4-17

14Enter the LES user part if you selected Manual for the LEC Configuration Mode.

This is the 7-byte hexadecimal (14-character) user part of the target LES address. Enter the address without delimiters.

For example:

0E4A2C27456200

15Select the VPI/VCI range.

The default value is 0 bits VPI, 12 bits VCI. This value is determined by the ATM switch settings and must be the same for all end stations on the network.

16Select the ILMI VPI.

The default value is 0. This value is determined by the ATM switch settings.

17Select the ILMI VCI.

The default value is 16. This value is determined by the ATM switch settings.

18Select the signaling version.

UNI 3.1 is the default value. Select the version of UNI supported by your switch.

19When you have set all the configuration values, press [F10] or [Esc] to move to the Driver Actions box.

20Select Save parameters and load driver.

The install utility writes the appropriate load and bind commands to the AUTOEXEC.NCF file and loads the LEC.

If no errors are encountered, the dialog box shown in Figure 4-10 appears.