3Com 155 PCI manual Reset, Describes the NIC information fields, PCI Slot Number, IRQ Level

5-6 CHAPTER 5: ATMLINK UTILITY

The bus number, slot number, and IRQ values are set by the system BIOS. The maximum number of VCCs is preset by the network driver. All other values are set by using the ATMLink install utility. See Chapter 3 for more information on configuring and reconfiguring NICs and ELANs.

Table 5-3 describes the NIC information fields.

Table 5-3 Windows NT NIC Information Fields

Field	Displayed Values
PCI Bus Number	Number of the PCI bus on which the selected NIC is installed
PCI Slot Number	Number of the PCI slot into which the selected NIC is inserted
IRQ Level	Interrupt request level assigned to the selected NIC by the
	operating system
Max Number of VCC	1024
VPI/VCI Range	■ 0 bits VPI, 12 bits VCI
	■ 1 bits VPI, 11 bits VCI
	■ 2 bits VPI, 10 bits VCI
	■ 4 bits VPI, 8 bits VCI
Signaling Version	■	UNI 3.0
	■	UNI 3.1
Max Frame Size	■ 1514—default value for Ethernet link type
	■ 4542—default value for 4 Mbps token ring link type
	■ 9232—default value for 16 Mbps token ring link type
Number of ELANs	0–16—number of LECs configured on selected NIC
Resiliency	■ Primary—the selected NIC is an active NIC
	■	Standby—the selected NIC is a standby NIC
Card State	■	Link up
	■	Link down

Reset

Selecting Reset from the Control menu reinitializes the network driver for the selected NIC. All link and ATM open connections of the NIC are momentarily lost, but reestablished when the driver reactivates.