Installing the VCN Access Point 23

Mounting the VCN To mount the VCN AP on a wall perform the following tasks.

Access Point on a

Wall

1Apply the paper template to the wall as shown in Figure 7.

Figure 7 Using the Paper Template to Mark the Wall

The partially curved edge of the template corresponds to the curved cover that is part of the VCN AP front panel.

2Remove the cover by sliding it downward and then pulling it outward. See Figure 8.

Figure 8 Removing Curved Cover

Screw hole

E TH E RN E T

Fax-M odem

Lin e

P o w e r

All three holes in the VCN AP are plugged.

3Remove the plugs from the two large holes by prying them out with the tip of your screwdriver.

4Remove the plug from the small hole by forcing it out from the bottom with a pointy instrument (for example a nail).

Page 23
Image 23
3Com DSA-3CV1001-02 service manual Access Point on a Wall, Apply the paper template to the wall as shown in Figure