3Com DSA-3CV1001-02 service manual Set Ethernet Half/Full Duplex Mode, Change Password

56CHAPTER 4: USING THE LOCAL MANAGEMENT ACCESS

Figure 51 Setting VLAN ID Message Screen.

Please enter your choice: 1

Note: In a topology with VCN Concentrator, this setting may override the concentrator agent settings. For more information please refer to the service manual.

Enter VLAN ID (1-4094, 0 for none) [none]: 2

Action has been done

Set Ethernet Half/Full Duplex Mode

To set Ethernet half/full duplex mode, perform the following steps:

1In the AP Configuration Menu enter 2.

2Enter the desired mode; a confirmation message appears.

Action has been done.

Change Password

To change the password, do as follows:

1In the AP Configuration Menu, enter 3.

2You are prompted to enter the old password followed by the new password and a confirmation, as in Figure 52:

Figure 52 Changing Password Message

Enter the old password:

Enter the new password (up to 8 characters):

Confirm new password (up to 8 characters):

The password was changed and saved in a non-volatile memory

If you forget your password, contact technical support. Refer to Appendix F Technical Support.