VCN Access Point Menus 57

Set to Factory Defaults

To set VCN AP to factory defaults perform the following steps:

1In the AP Configuration Menu, type 4 and press <Enter>; a warning message that the action will set the system to their default value appears:

This action will return the system parameters to their default values!

Do you want to proceed (Y/[N])?:

2Type y and press <Enter>; the system is set to factory default. The following messages appear:

The factory’s default settings were written to the

non-volatile memory

Note: some of the changes will take effect after reset

Closing the Local When you are finished using the local management menus, exit your Management terminal emulation program and disconnect your personal computer

Interface from the Local Management port.

Page 57
Image 57
3Com DSA-3CV1001-02 service manual Set to Factory Defaults, Interface from the Local Management port