FIC-4BSE 181

Figure 223 FIC-1CT3 panel

The following table describes the LEDs on the card panel.

Table 125 LEDs on the FIC-1CT3 panel

LED

Description

 

 

LINK/ACT

ON means the carrier signal has been

 

received.

 

OFF means no carrier signal has been

 

received.

 

Blinking means data is being transmitted

 

or/and received.

 

 

LP/AL

ON means the interface is in a loopback.

 

Blinking means an AIS, LFA, or RAI alarm

 

signal is present.

 

OFF means no loopback or alarm is

 

present.

 

 

Note:

 

AIS = Alarm indication signal; LFA = loss of frame alignment; RAI = Remote alarm indication

Interface Cable Refer to “FIC-1CE3” on page 178.

The interface cable for the FIC-1CT3 is the same as that for the FIC-1CE3 and is connected in the same way.

FIC-4BSE

Introduction FIC-4BSE, the four-port ISDN BRI interface card, transmits, receives, and processes four channels of ISDN BRI S/T data traffic on ISDN BRI S/T interfaces.

The FIC-4BSE differs from the FIC-4BS only in the way they set matched resistance for an ISDN BRI S/T interface: the FIC-4BS uses jumpers while the FIC-4BSE uses DIP switches.

The FIC-4BSE can work in dial mode or leased line mode.

Interface Attributes The following table describes the interface attributes of the FIC-4BSE.

Table 126 Interface attributes of the FIC-4BSE

Attribute

Description

 

 

Connector

RJ-45

Number of connectors

4

Page 181
Image 181
3Com MSR 20, MSR 30, MSR 50 manual LEDs on the FIC-1CT3 panel, Interface attributes of the FIC-4BSE