SIC-1ADSL-I 53

Table 26 LEDs on the SIC-1ADSL panel

 

 

 

LED

Description

 

 

LINK

OFF means the loop is inactive.

 

ON means the loop has been activated and

 

has entered the data mode

 

Blinking means the loop is being activated.

ACT

OFF means no data is being transmitted or

 

received; blinking means data is being

 

received or/and transmitted.

 

 

Interface Cable The interface cables that the SIC-1ADSL uses are regular telephone cables.

n The standard equipping package of the SIC-1ADSL includes the regular telephone cable(s). You can separately order an external splitter as needed.

Connecting the Interface In G. Lite mode, no splitter is needed. You can directly connect the router to the Cable PSTN using a telephone cable, and simply connect the phone-set in parallel with

the router at the cable distribution box.

In full rate mode, a splitter is required. Follow these steps to connect the cables:

Step 1: Plug one end of a telephone cable into the ADSL port on the router, and the other end into the internal ADSL port on the splitter.

Step 2: Connect the telephone to the phone port on the splitter with another telephone cable.

Step 3: Connect the external ADSL port on the splitter to the PSTN with a third telephone cable.

Figure 48 Connecting the SIC-1ADSL

Router

RJ11 interface

 

 

POS

 

Splitter

Modem interface ADSL card

Phone port

PSTN

Line port

DSLAM

SIC-1ADSL-I

Introduction SIC-1ADSL-I, the 1-port ADSL over ISDN interface card, uses the RJ-11 connector for the WAN interface. It allows a LAN subscriber to connect to the DSLAM at the central office over a regular analog subscriber line or telephone line. Thus, the subscriber can access the ATM/IP backbone or the Internet to enjoy services such as high-speed data communication and video on demand (VoD).

Page 53
Image 53
3Com MSR 50, MSR 30, MSR 20 manual SIC-1ADSL-I, Connecting the SIC-1ADSL