178CHAPTER 4: FLEXIBLE INTERFACE CARDS

At one end of the cable is a DB-68 connector for connecting the router and at the other end are eight RJ-45 connectors for connecting other devices.

Connecting the Interface

Cable

c CAUTION: Before you connect a port, read its label carefully; a wrong connection can impair the interface card and even damage the device.

If the interface cable is routed outdoors, you are recommended to install a special lightning arrester at the input end of the interface cable for better lightning protection.

Step 1: Insert the DB-68 connector of the 8T1 conversion cable to the DB-68 port on the FIC-8T1/FIC-8T1-F card.

Step 2: Connect one RJ-45 connector at the other end of the cable to the device to be connected.

Step 3: Power on the router. Check the behavior of the LINK LED on the card

panel: OFF means fault occurs on the line. Check the line status.

FIC-1CE3

Introduction FIC-1CE3, the 1-port channelized E3 interface card, delivers these functions:

 

In E3 mode, transmitting, receiving, and processing one channel of E3 fast

 

traffic; providing E3 traffic access.

 

In CE3 mode, providing the subscribers with N 64 kbps low-speed access,

 

where N is smaller than or equal to 128.

n

E3 represents the tertiary group rate of E system in the TDM system, that is,

34.368 Mbps. Through E23 and E12 demultiplexing, an E3 channel can be

 

channelized into 16 E1 lines, each supporting both the E1 and CE1 modes. E23

 

means either E2-to-E3 multiplex or E3-to-E2 demultiplex, and E12 means

 

E1-to-E2 multiplex or E2-to-E1 demultiplex. “E23” and “E12” discussed here

 

represent the demultiplex process.

Interface Attributes The following table describes the interface attributes of the FIC-1CE3/FIC-2CE3.

Table 122 FIC-1CE3 interface attributes

Attribute

Description

 

 

Connector

SMB

Number of connectors

2

Interface standard

G.703

 

G.704

 

G.751

Interface rate

34.368 Mbps

Cable type

E3 cable (75-ohm coaxial cable)

Page 178
Image 178
3Com MSR 20, MSR 30, MSR 50 manual Represent the demultiplex process, FIC-1CE3 interface attributes