SIC-1VE1 45

Step 2: Check the status of LINK LED on the GEC panel: ON means the link is connected and OFF means the link is not connected. In the latter case, check the line.

SIC-1VE1

Introduction 1-port E1 voice interface card (SIC-1VE1) can handle dense voice signals in VoIP

 

system. It provides a CE1/PRI/R2 port, allowing the access of 30 channels of voice

 

signals.

 

n

When purchasing a SIC-1VE1 interface card, users should purchase a VCPM

and configure a VPM based on voice traffic.

 

No VCPM is required, but only a VPM needs to be installed on the main board

 

when MSR 20-1x series routers need to be equipped with a SIC-1VE1 interface

 

card.

 

 

VCPM and VPM need to be installed on the main board when MSR 30 series

 

routers need to be equipped with a SIC-1VE1 interface card.

 

VCPM and VPM need to be installed on the MSCA card when MSR 50 series

 

routers need to be equipped with a SIC-1VE1 interface card.

Interface Attributes

Table 20 Interface Attributes of the SIC-1VE1

 

 

 

 

 

 

 

Attribute

Description

 

 

 

 

Connector

DB 15

 

Number of connector

1

 

Interface standard

G.703, G.704

 

Interface rate

2.048 Mbps

 

Frame format

Ethernet_II

 

 

Ethernet_SNAP

 

 

IEEE 802.2

 

 

IEEE 802.3

 

Cable type

75-ohm non-balanced coaxial cable

 

 

120-ohm balanced twisted pair cable

 

 

Coaxial connector, network interface

 

 

connector and 75-ohm to 120-ohm

 

 

adapter (with BNC connector)

 

Operation mode

CE1

 

 

ISDN PRI (only supported by SIC-1VE1)

 

 

R2

 

Services

Backup

 

 

Terminal access

 

 

ISDN (only supported by SIC-1VE1)

 

 

 

DIP Switches CE1/PRI/R2 interface is compatible with 75-ohm and 120-ohm impedance. Matching of different impedance is implemented through an 8BIT DIP switch. By default, all the DIP switches are set to ON, as illustrated in the following figure:

Page 45
Image 45
3Com MSR 30, MSR 20, MSR 50 manual SIC-1VE1, Signals, Configure a VPM based on voice traffic, Card