3Com MSR 20, MSR 30, MSR 50 manual MIM-1CE3 Module, Accessing of E3 traffic when working in E3 mode

MIM-1CE3 Module 97

Step 2: Connect one RJ-45 connector at the other end of the cable to the device to be connected.

Step 3: Power on the router. Check the behavior of the LINK LED on the module panel. It is OFF when fault has occurred on the link and signal is out of synchronization. In this case, please check the link.

MIM-1CE3 Module

Introduction 1-port channelized E3 interface module (MIM-1CE3) serves to:

	■ Transmit/Receive and handle one channel of E3 fast traffic, as well as provide
	the accessing of E3 traffic when working in E3 mode; and
	■ Provide the low-speed accessing service at the speed of n ⋅ 64 kbps, where n is
	smaller than or equal to 128, when working in CE3 mode.
n	■ E3 represents the tertiary group rate of E system in the TDM system, that is,
	34.368Mbps. An E3 channel can be channelized into 16 E1 lines through the
	demultiplexing processes of E23 and E12, each E1 line supporting both the
	operating modes of E1 and CE1. E23 is used to indicate either E2-to-E3
	multiplex or E3-to-E2 demultiplex, and E12 to indicate E1-to-E2 multiplex or
	E2-to-E1 demultiplex. “E23” and “E12” discussed here represent the
	demultiplex process.
	■ The two E3 channels of 2CE3 can work in E3 and CE3 mode respectively.
Interface Attributes The interface attributes of MIM-1CE3 are given in the following table:
	Table 56 Interface attributes of 1CE3
	Attribute	Description
	Connector	SMB
	Number of connectors	2
	Interface standard	G.703, G.704, G.751
	Interface rate	34.368 Mbps
	Interface cable type	E3 cable (75ohm coaxial cable)
	Operating mode	E3
		CE3
	Supported service	E3 leased line

Interface LEDs MIM-1CE3 panel is shown in the following figure:

Figure 110 MIM-1CE3 panel

The following table describes the LEDs on the MIM-1CE3 panel: