226CHAPTER 4: FLEXIBLE INTERFACE CARDS

DFIC-24FXO24FXS

Introduction The DFIC-24FXO24FXS provides 24-port voice subscriber circuit and 24-port voice AT0 analog trunk circuit. FXS interfaces process and transmit voice signals over data communications networks for 24 regular analog phones, faxes, or AT0 loop trunks of telephone exchanges. The FXO interfaces process and transmit voice signals over data communications networks for 24 loops of telephone exchanges.

Interface Attributes

Table 169 Interface attributes of the DFIC-24FXO24FXS module

Attribute

Description

 

 

Connector

50-pin D-type female connector

Interface standard

FXS and FXO interface

Interface rate

24 FXO interface rate plus 24 FXS

 

interface rate

 

 

Interface LEDs DFIC-24FXO24FXS has two kinds of LEDs, Active and Link.

Table 170 Description of LEDs on the DFIC-24FXO24FXS panel

LED

FXO interface

FXS interface

Active

OFF means all links are idle.

 

Blinking means one or more

 

links are occupied.

Link

Steady ON if an electric device

 

is connected.

OFF means all links are idle. Blinking means one or more links are occupied.

Steady ON means no fault occurs on the link

The following figure illustrates the DFIC-24FXO24FXS panel.

Figure 278 DFIC-24FXO24FXS front panel

Interface Cable DFIC-24FXO24FXS uses a 5 m (16.4 ft.) or 15 m (49.2 ft.) telephone conversion cable. At one end of the cable is a D50 male connector that is used to connect to the DFIC-24FXO24FXS card; at the other end are 24 RJ11 connectors.

Page 226
Image 226
3Com MSR 20 Following figure illustrates the DFIC-24FXO24FXS panel, Interface attributes of the DFIC-24FXO24FXS module