3Com MSR 50, MSR 30 XMIM-16FSW/XMIM-2 4FSW, MIM-1SHL-4W and the other end to Dslam through Pstn

XMIM-16FSW/XMIM-24FSW 143

Figure 163 Type “Y” cable

■As shown in the following figure, on both ends of the “I” type G.SHDSL cable there is an RJ-11 connector. The “I” type G.SHDSL cable can connect one 4-wire telephone cable.

Figure 164 “I” type cable

Connecting the Interface	■	When using the “Y” cable, connect the X1 end of the cable to the interface on
Cable		MIM-1SHL-4W and connect the other two ends (X2, X3) to DSLAM through
		PSTN.
	■	When using the “I” cable, connect one end of the cable to the interface on
		MIM-1SHL-4W and the other end to DSLAM through PSTN.

XMIM-16FSW/XMIM-2 4FSW

Introduction	XMIM-16FSW and XMIM-24FSW are a 16-port 10/100 Mbps Ethernet Layer 2
	switching MIM interface card and a 24-port 10/100 Mbps Ethernet Layer 2
	switching MIM interface card, which can be installed on the MSR 30-11. Each
	XMIM-16FSW provides sixteen ordinary 10/100 Mbps RJ45 connector interfaces,
	while each XMIM-24FSW provides twenty-four 10/100 Mbps RJ45 connector
	interfaces. Both XMIM-16FSW and XMIM-24FSW are suitable for a small
	enterprise network to serve as a switching & routing device, which can be directly
	connected to PCs and network devices of the enterprise. XMIM-16FSW and
	XMIM-24FSW support the following functions:
	■ A transmission distance of 100 meters (328.1 ft.) when connected with a
	category-5 twisted pair cable (crossover or straight-through cable).
	■ 100 Mbps wire-speed forwarding between any ports when connected with a
	category-5 twisted pair cable (crossover or straight-through cable).
	■ Auto-sensing at a rate of 10 Mbps or 100 Mbps.
	■ Full duplex and half duplex, of which full duplex is common.
Interface Attributes	Table 100 Interface attributes of XMIM-16FSW/XMIM-24FSW
	Attributes	XMIM-16FSW/XMIM-24FSW
	Connector type	RJ45
	Interface type	MDI/MDIX