Managing the AMASS File System
ADIC Scalar 1000
AMASS does not support automatic drive cleaning on the
ADIC Scalar 1000 with firmware earlier than level 2.10.
Consequently, the Cleaning Mode must be disabled as follows:
Step 1. From the operator panel, enter the Main menu by pressing Escape 
.
Step 2. Scroll the Main menu using the navigation buttons
or 
. Select the Setup menu by pressing
Enter
.
Step 3. Scroll the Setup menu using the navigation buttons, and select the Cleaning menu by pressing Enter.
Step 4. Scroll the Cleaning menu using the navigation buttons, and select the Drives dialog box by pressing Enter.
Step 5. Determine if the first line in the box that shows if automatic drive cleaning is disabled reads, “Auto Clean: N”. If so, no further action is required. Press the Escape button until you reach the Status Display menu (the initial screen).
However, if the first line shows that automatic drive cleaning is enabled, “Auto Clean: Y”, change the Y to an N with the navigation buttons.
Move to the “ACCEPT:N” part of the screen by pressing Enter, and change the N to a Y with the navigation buttons.
Step 6. Save the changed cleaning state by pressing Enter.
Step 7. Press Escape until you reach the Status Display menu (the initial screen).
Command Reference |