Agilent Technologies E1563A, E1564A user manual DIAGnosticPOKE

DIAGnostic:POKE

Parameters

Comments

DIAGnostic:POKE <reg_number>,<data> places the specified value in the specified register.

Name	Type	Range of Values	Default Value
reg_number	numeric	2-4, 14-16, 18-31	none
data	numeric	-32768 to +32767	none
		(signed integer)
		0 to 65535
		(unsigned integer)

Writing to Registers: See Appendix B for register bit definitions.You can write to the following digitizer registers using the register number. For example, to write to the Range, Filter, Connect Channels 1 and 2 register to set channel 1 and 2 ranges to 64V and set the filters to 100 kHz, execute DIAG:POKE 18,13621. The binary bit pattern for +13621 is 0011010100110101

reg_number Register Description (base + register offset)

2Status/Control Register (base + 0416)

3 Offset Register (base + 0616)

6 Interrupt Control Register (base + 0C16)

14Calibration Flash ROM Address Register (base + 1C16)

15Calibration Flash ROM Data Register (base + 1E16)

16Calibration Source Register (base + 2016)

18Range, Filter, Connect Chs 1 and 2 Register (base + 2416)

19Range, Filter, Connect Chs 3 and 4 Register (base + 2616)

20Trigger/Interrupt Level Channel 1 Register (base + 2816)

21Trigger/Interrupt Level Channel 2 Register (base + 2A16)

22Trigger/Interrupt Level Channel 3 Register (base + 2C16)

23Trigger/Interrupt Level Channel 4 Register (base + 2E16)

24Sample Period High Word Register (base + 3016)

25Sample Period Low Word Register (base + 3216)

26Pre-Trigger Count High Register (base + 3416)

27Pre-Trigger Count Low Register (base + 3616)

28Post-Trigger Count High Register (base + 3816)

29Post-Trigger Count Low Register (base + 3A16)

30Trigger Control/Source Register (base + 3C16)

31Sample Control/Source Register (base + 3E16)

Executable when initiated: NO

Coupled Command: NO

Reset (*RST) Condition: None

Chapter 3 Digitizers Command Reference 69