Agilent Technologies N6700 manual Programming High-Speed Test Extensions, List Function

Operating the Power System 4

Programming High-Speed Test Extensions

	The High-Speed Test Extensions described in this section are not available on
NOTE
	all models (Refer to Chapter 1, “Model Differences”).

The List Function

	Either output voltage or output current, or both together, may be list-
	controlled. List mode lets you generate complex sequences of output
	changes with rapid, precise timing, which may be synchronized with
	internal or external signals. Lists can contain up to 512 individually
	programmed steps, and can be programmed to repeat themselves.
	The voltage and current lists are paced by a separate list that defines
	the duration or dwell of each step. Each of the up to 512 steps can
	have an individual dwell time associated with it, which specifies the
	time in seconds that the list will remain at that step before moving on
	to the next step. Dwell times can be programmed from 0 to 262.144
	seconds. The default dwell time is 0.001 seconds.
	If you need an output list to closely follow external events, then a
	trigger-paced list is more appropriate. In a trigger-paced list, the list
	advances one step for each trigger received. As previously discussed,
	a number of trigger sources can be selected to generate triggers. With
	a trigger-paced list, you do not need to program a dwell time for each
	step. If you do program a dwell time, triggers that are received during
	the dwell period are ignored.
	Voltage and current lists can also be configured to generate trigger
	signals at specified steps. This is accomplished by two additional
	lists: a beginning-of-step (BOST) and an end-of-step (EOST) list.
	These lists define which steps will generate a trigger signal and if the
	trigger occurs at the beginning or end of the step. These trigger
	signals can be used to synchronize other events with the list.
	When either a voltage or current list is programmed, the associated
	dwell, BOST, and EOST lists must all be set to the same number of
	steps, otherwise an error will occur when the list is run. For
	convenience, a list may be programmed with only one step or value.
	In this case, a single-step list is treated as if it had the same number
	of steps as the other lists, with all values being equal to the one value.
	List data is not stored in non-volatile memory. This means that list data that is
NOTE
	sent to the instrument either from the front panel or over the bus will be lost
	when the power system is turned off.

Series N6700 User’s Guide 65