Agilent Technologies N6700 Front Panel Scpi Command Select Transient\List\Repeat, Inittran @1

Operating the Power System 4

Step 5. To generate a pulse train, you can simply repeat the pulse as needed. For example, to program a pulse train of 50 pulses, use:

Front Panel:	SCPI Command:
Select Transient\List\Repeat.	To program output 1, use
Enter the number of list repetitions	LIST:COUN 50, (@1)
(50) and Press Select.

Step 6. Specify if you want the output pulse to generate a trigger signal that can be used to trigger actions on other output channels or on any external equipment connected to the digital port. For example, to generate a trigger signal at the end of the pulse, use:

Front Panel:	SCPI Command:
Select Transient\List\Config.	To program a trigger at the End of the
Select List Step 0 and check the	pulse for output 1, use
Tout Step box. Press Select.	LIST:TOUT:EOST 1,0, (@1)
	You must program a value of 0 (no
	trigger) for step 1 as a placeholder.

Step 7. Specify the output state after the pulse has completed. For example, to return the output to the state it was in before the pulse, use:

Front Panel:	SCPI Command:
Select Transient\List\Terminate.	To program output 1, use
Select Return to Start. Press Select.	LIST:TERM:LAST 0, (@1)

Step 8. Select the trigger source that will generate the pulse or pulse train. For example, to select Bus triggers as the trigger source, use:

Front Panel:	SCPI Command:
Select Transient\TrigSource.	To program output 1, use:
Select Bus and press Select.	TRIG:TRAN:SOUR BUS, (@1)

Step 9. Initiate the output trigger system. To enable the trigger system for one transient event or trigger use:

Front Panel:	SCPI Command:
Select the Transient\Control.	To program output 1, use
Select Initiate and Press Select.	INIT:TRAN (@1)

Step 10. Trigger the output pulse or pulse train.

Front Panel:	SCPI Command:
Select Transient\Control.	*TRG
Select Trigger and Press Select.

Series N6700 User’s Guide 67