Agilent Technologies N6700 manual Grouping the Outputs, Firmware revision B.00.00 and up

OUTPUT 2 OUTPUT 1

+S + -S +S + -S

SENSE	TWIST LEADS	SENSE
		JUMPERS
JUMPERS
		INSTALLED
INSTALLED

OUTPUT 2

+S + -S

TWIST

LEADS

Installation 2

OUTPUT 1

+S + -S

+

LOAD

+

LOAD

WITH LOCAL SENSING WITH REMOTE SENSING

The following figure shows the connections for 50A power modules.

OUTPUT 3

+

+S +LS -LS -S

OUTPUT 1

+

+S +LS -LS -S

OUTPUT 3

+

+S +LS -LS -S

OUTPUT 1

+

+S +LS -LS -S

SENSE

JUMPERS

INSTALLED

TWIST LEADS

+

LOAD

WITH LOCAL SENSING

TWIST

LEADS

+

LOAD

WITH REMOTE SENSING

Grouping the Outputs

	The ability to group outputs is only available on power system mainframes with
NOTE
	firmware revision B.00.00 and up.
	Once outputs have been connected in parallel, they can be configured
	or “grouped” to act as a single, higher-power channel. This applies
	when programming via the front panel or using SCPI commands.
	How to group output channels that have been connected in parallel is
	discussed in Chapter 4 under “System-Related Operations”.

Series N6700 User’s Guide 31