Panasonic A4P Series Display of Regenerative Load Factor, Display of Over-load Factor

How to Use the Console

Display of Regenerative Load Factor

Shows regenerative resistance load factor in percentage assuming that an operation level of regenerative protection is 100%.￿

This is valid when SV.Pr6C is 0 or 1.

Display of Over-load Factor

Displays the ratio (%) against the rated load. ￿￿

Refer to P.170, "Overload Protection Time Characteristics" of When in Trouble.

Display of Inertia Ratio

Displays the inertia ratio (%) .￿￿

Value of SV.Pr20 (Inertia ratio) will be displayed as it is.

Display of Feedback Pulse Sum, Command Pulse Sum

(lowestorder ￿)

Press .

(highestorder ￿)

Total sum of pulses after control power-ON. ￿

The display range is from –2147483647 to 2147483647.￿ An overflow occurs if the result is outside the display range.￿

Sum of pulses shown can be reset to “0” by pressing ￿ for approximately 5 seconds or more.

Display of External Scale Deviation, External Scale Feedback Pulse Sum

Press	.		* Not available to the models that do not
			support external scale.
		(lowestorder ￿)
Press	.
	Press	.

(highestorder ￿)

Automatic Motor Recognizing Function

Automatic recognition is valid. (This is always shown.)

Switching of the Driver to be Communicated

RS232 communication

.....“1” is always shown.

86