Panasonic A4P Series instruction manual Point specifying, Input logic setting

					[Setting]
					Standard default : < >
Servo￿	Title	Setup￿			Function/Content
PrNo.		range
58	Point specifying ￿	0 to 1￿	Set the logic of the point specifying inputs (P1IN to P32IN: CN X5 Pin 3, 4, 5, 6, 7 and 8).
	input logic setting	<1>
				Setup value￿	Description￿
				0￿	Point specifying inputs are enabled by opening the connection to COM–.￿
				<1>	Point specifying inputs are enabled by closing the connection to COM–.
59	Multi-function ￿	0 to 1￿	Set the logic of the multi function input 1 (EX-IN1: CN X5 Pin 22).
	input 1 Signal logic	<1>
				Setup value￿	Description￿
				0￿	Input is enabled by opening the connection to COM–.￿
				<1>	Input is enabled by closing the connection to COM–.
5A￿	Multi-function ￿	0 to 6￿	Set the function of the multi function input 1 (EX-IN2: CN X5 Pin 22).
*	input 1 Signal ￿	<0>
				Setup value￿	Description￿	Setting
	selection			1￿	Immediate stop￿
				<0>￿	Disabled (regardless of the logic setting in SV.Pr59).￿
				2￿	Temporary stop￿
				3￿	Deceleration and stop￿
				4￿	High-speed normal rotation jog￿
				5￿	High-speed reverse rotation jog￿
				6	Alarm is cleared.
5B	Multi-function ￿	0 to 1￿	Set the logic of the multi function input 2 (EX-IN2: CN X5 Pin 25).
	input 2 Signal logic	<1>
				Setup value￿	Description￿
				0￿	Input is enabled by opening the connection to COM–.￿
				<1>	Input is enabled by closing the connection to COM–.
5C￿	Multi-function ￿	0 to 6￿	Set the function of the multi function input 2 (EX-IN2: CN X5 Pin 25).
*	input 2 Signal ￿	<0>
				Setup value￿	Description￿
	selection			<0>￿	Disabled (regardless of the logic setting in SV.Pr5B).￿
				1￿	Immediate stop￿
				2￿	Temporary stop￿
				3￿	Deceleration and stop￿
				4￿	High-speed normal rotation jog￿
				5￿	High-speed reverse rotation jog￿
				6	Alarm is cleared.
			<Note>￿
			The setting of the multi function input 1 and that of the multi function input 2 must be
			different from each other. Moreover, if high-speed normal rotation jog and high-
			speed reverse rotation jog are assigned to the input 1 and input 2, respectively, the
			motor does not work when those turn on simultaneously.
5D	Servo-ON input	0 to 1￿	Specify whether to enable or disable the servo-on input (SRV-ON: CN X5 Pin 23).
	valid	<1>
				Setup value￿	Description￿
				￿	Disable: ￿
				0￿	A servo turns on after the power supply turns on, regardless of the state
				￿	of servo-on input (SRV-ON: CN X5 Pin 23).￿
				￿	Enable: ￿
				<1>	A servo turns on when the servo-on input (SRV-ON: CN X5 Pin 23) has
					been input after the power supply turns on.

67