Panasonic A4P Series instruction manual How to Use the Console, Setup with the Console

How to Use the Console

Setup with the Console

Composition of Display/Touch panel

Display LED (6-digit)￿

All of LED will flash when error occurs, and switch to error display

screen. ￿

￿

Display LED (in 2 digits) ￿

Parameter No. is displayed at parameter setup mode. Point No. is

displayed at teaching mode.￿

￿

SHIFT Button ￿

Press this to shift the digit for data change.￿

￿

Button ￿

Press these to change data or execute selected action of parameter.￿

Numerical value increases by pressing ,,￿

decreases by pressing .￿

￿

SET Button￿

Press this to shift each mode which is selected by mode switching button to EXECUTION display.

Mode Switching Button Press this to switch￿ 7 kinds of mode.￿

1)	Monitor mode￿	5)	Normal auto-gain tuning mode￿
2)	Teaching mode￿	6)	Auxiliary function mode￿
	• Target position settings established ￿		• Alarm clear￿
	by teaching￿		• Absolute encoder clear￿
	• Test operation￿	7)	Copy mode￿
3)	Parameter setup mode￿		• Copying of parameters from the driver to the console.
4)	EEPROM write mode		• Copying of parameters from the console to the driver.

Initial Status of the Console Display (7 Segment LED)

Turn on the power of the driver while inserting the console connector to the driver main body, or inserting the console connector to CN X4 connector.

0.6 sec 0.6 sec 0.6 sec

[flashes for approx. 0.6 sec each for initialization of the console]

• In case of communication with RS232 only

Displays version No. of micro computer of the console. ￿ (Displayed figures vary depending on the version)￿

￿

1 sec

Initial display of LED￿

(Determined by the setup of SV.Pr01, "Initial Status of LED".)

• Release of RS232 communication error￿

When RS232 communication error occurs as the Fig, below shows, ￿ release it by pressing and at the same time.

80