Carrier Access Access Navigator Router Provisioning Quick Guide, Adit CLI Commands Descriptions

	Provision Remote Adit 600 via IP DS0
		Router Provisioning Quick Guide
Access Navigator CLI Commands		Descriptions
set ds0 <n:ch> up		Set DS0s in service.
set ds1 <n> up		Set DS1s in service.
status remote <n>		Verify status of management channel.

Router Provisioning Quick Guide

NOTE: The following commands assume that the Router card is in slot 1.

NOTE: The remote Adit WAN address MUST have a different subnet than the Adit Controller address.

Adit CLI Commands	Descriptions
set local off	Sets Adit to be configured through
	CLI.
set a:2 down	Sets T1-2 out of service.
disconnect a	Disconnects all connections to slot a
	(controller).
set a:1:24 type data	Sets all DS0s on T1-1 to data
	signalling type.
connect a:1:1 1:1:1	Connects DS0s on controller T1-1 to
connect a:1:2 1:1:2	DS0s of port 1, WAN 1 to 24, of
connect a:1:24 1:1:24	Router in slot 1.
	Repeat for all 24 channels.

Router Setup

Telnet into Router by specifying {slot}:{port}.

Example: telnet 1:1

Enter password (default is "admin") and press Enter key.

Note: Once you are in the Router, the Tab key will move you through the menus and the Spacebar will scroll you through selections in <>.

Select Terminal Emulation (scroll with Tab key) and press Enter key.

Access Navigator - Release 1.8 August 2003 13-5