Carrier Access Access Navigator user manual Configure Remote T1 Drop Interface if used

Provision Remote Access Bank II

Configure Remote T1 Drop Interface (if used)

Configure Remote T1 Drop Interface (if used)

CAUTION! IF THE T1 DROP WILL BE USED, THE T1 DROP CIRCUIT OR LOOPBACK MUST BE INSTALLED BEFORE DOWNLOADING THE CONFIGURATION, OTHERWISE THE RESULTING AIS ALARM WILL TAKE DOWN THE FDL COMMUNICATIONS LINK UNTIL THE CIRCUIT IS INSTALLED AND THE ALARM IS CLEARED.

NOTE: This is a second T1 connection on the Access Bank II, not the T1 connection between the Access Navigator and the Access Bank II.

1.Show current remote interface settings with the following command: show remote <nall>

Example: show remote 11

Example: show remote all

The show command will display the remote interface settings the each DS1 specified, or for all DS1s. For example, the message for showing DS1 number 11 would look similar to the following:

Settings for remote device Remote Device #11:

Remote	Config:	disabled
T1 Drop Port:		AMI
Line	Coding:
Framing:		D4
Line	Build Out:	DSX-1 0-133 ft. (or 0 db)
PRM:		AT&T
V.35 Port:		Always High
CTS:
Rx Timing:		Internal
Clock Inversion:		None
Data	Inversion:	Normal
Speed:		Nx64
DSU:		On
RS232 Port:		9,600
Baud	Rate:
Data	Bits:	8
Parity:		None
Stop	Bits:	1

2. If drop T1 Drop settings are correct, skip remaining steps.

11-24 August 2003 Access Navigator - Release 1.8