Carrier Access Access Navigator user manual Provision Groom DS1 Circuits to Network, Cac

Provision DCS Service

Provision “Groom” DS1 Circuits to Network

Provision “Groom” DS1 Circuits to Network

1.Show groom DS1 settings with the following command: show ds1 <n>

Example: show ds1 10

The show command will produce a message showing the DS1 settings. For example, the message for DS1 number 10 might look similar to the following:

Settings for DS1 10:	CA DS1# 10
Circuit ID:
Up/Down:	DOWN
Framing:	ESF
Line Coding:	B8ZS
Type:	DROP
Clock Source:	NORMAL
Line Build Out:	DSX-1 EQUALIZATION FOR 0-133 ft.
Loop Code Detection:	OFF
Loop Back:	OFF
Line Termination ID:	0 (for switch DS1s only)
FDL Type:	CAC
Send Code:	None	15 min.	1 hour	1 day
Performance Thresholds:
unavailable seconds:		--------	-------	------
		0	0	0
severely errored seconds:		0	0	0
errored seconds:		0	0	0
sev. errored frame seconds:		0	0	0
degraded minutes:		0	0	0
linecode violations:		0	0	0

NOTE: In the above message loop back test function is turned off and the send code set to none during normal service. Line Termination IDs are used only for GR-303 switch DS1s.

2.If groom DS1 settings are correct, skip remaining steps.

3.Set DS1 type to “groom” with the following command: set ds1 <n> type groom

Example: set ds1 10 type groom

4.Set groom DS1 frame type to D4 or ESF with the following command: set ds1 <n> framing <d4esf>

Example: set ds1 10 framing esf

9-12 August 2003 Access Navigator - Release 1.8