Carrier Access Access Navigator user manual Remote Adit 600 FDL Provisioning Quick Guide

Provision Remote Adit 600 via FDL

Remote Adit 600 FDL Provisioning Quick Guide

Remote Adit 600 FDL Provisioning Quick Guide

CLI Commands		Descriptions
status equipment		Verify equipment configuration.
show ds1 <n>all>		Verify service status.
status ds1 <n>
status ds0 <n:ch>
set ds1 <n> down		Set unused circuits out of service
set ds0 <n:ch> down		(down). If the DS1 is not terminated,
set ds0 <n:ch> type <voicedata>		set the DS0 type of all channels to
		data. If the DS1 is terminated, set the
		DS0 type of any unused channels to
		match the DS0 type (voice or data)
		configured on the device at the other
		end of the DS1.
set ds1 <n> type drop		DS1 type for remote Adit 600.
set ds1	<n> framing <d4esf>	DS1 framing. Use ESF for FDL.
set ds1	<n> linecode <amib8zs>	DS1 line code. Use B8ZS for FDL.
set ds1	<n> id <"id">	DS1 identifier.
set ds1	<n> clock <normalloop>	DS1 clock source.
set ds1	<n> fdl none	DS1 FDL type for remote Adit.
set ds1 <n> remote device mgmt cafdl		Set drop DS1 to remote Adit on to use
		Carrier Access FDL protocol.
set ds1 <n> remote device mgmt ds1 <n>		Set all other drop DS1s to same
		remote Adit to point to DS1 using
		CAFDL.
set ds1 <n> lbo <setting>		DS1 line buildout.
set ds1 <n> loopdetect <onoff>		Usually off for drop DS1s.
show connect <n>		Verify DS0 crossconnections.
disconnect <n:ch>		Remove old DS0 connections (if any).
set ds0 <n:ch> type <voicedatagr303>		DS0 type.
set ds0 <n:ch> signal <lsgsem>		DS0 signaling (voice or GR-303 types
		only).
connect <n:ch> <n:ch>		Add DS0 crossconnections.

12-4 August 2003 Access Navigator - Release 1.8