Carrier Access Access Navigator user manual DS0 #10

Provision DCS Service

Provision and Connect DS0s

NOTE: DS0 voice channels use robbed-bit signaling, while DS0 data are clear channels (no signaling). ISDN PRI DS0 passthrough channels and ISDN BRI 3DS0 channels must be set to DS0 Type Data.

4.Set DS0 type to voice or data with the following command: set ds0 <n:ch> type <voicedata>

Example:	set ds0 10:1-18 type voice
Example:	set ds0 10:19-24 type data

5.Set DS0 signaling (voice only) to Loop Start (ls), Ground Start (gs), or E&M (em) signaling with the following command:

set ds0 <n:ch> signal <lsgsem>

Example: set ds0 10:1-18 signal gs

6.Connect DS0s (see crossconnect examples in Figure 9-4) to make 2-way connections between DS0s, or fractional groups of DS0s, with the following command:

connect <n:ch> <n:ch>

Example: connect 10:19-24 5:1-6

DS0 #16

(A)DS1 #10

DS0 #3

(B)DS1 #12

DS0 #7

(C)DS1 #15

DS0 #17-24

(D)DS1 #16

Command Examples: (A)

(B)

(C)

(D)

Access Navigator

			DS0 #10
			DS0 #21
			DS0 #4
			DS0 #5-12
connect	ds0	10:16 18:21
connect	ds0	12:3	17:10
connect	ds0	15:7	21:4
connect	ds0	16:17-24 21:5-12

DS1 #17

DS1 #18

DS1 #21

Figure 9-4 Crossconnect Examples

9-18 August 2003 Access Navigator - Release 1.8