Carrier Access Access Navigator user manual EOC Major Alarm Message and Trouble Clearing Procedure

Alarm Clearing

Clear Alarms – EOC

Table 14-5. EOC Major Alarm Message and Trouble Clearing Procedure

Event Message	Description	Trouble Clearing Procedure
Alarm Count List	Event Report Service Problem.	The alarm is cleared after all
Change	(Reported only if the alarm count	events reportable to the switch
	list has been created. The alarm	have been cleared.
	count list is created by DMS
	switches.)
	The number of alarms active in the
	Access Navigator has changed.
	Only those alarms reportable to
	the switch and excluding Service
	Problems are included in the alarm
	count list.
DS1 Card n Removed	Event Report Line Card Problem.	Insert a Quad T1 Framer card, or
While In Service	Quad T1 Framer card removed	provision all four DS1s as out of
	while one or more of the four	service. Use following CLI
	DS1s were provisioned as in-	command to change service state:
	service.	set ds1 <n> <updown>
DS1 n Loss of Frame	Event Report LOF Problem. DS1	Correct the problem with the
	has LOF (Loss of Frame) – there is	incoming DS1 signal, or use
	a signal present but the DS1	following CLI command to
	receiver is not framed to it. This	provision the DS1 as out of
	alarm occurs if the DS1 is set for	service:
	ESF and the incoming signal is D4	set ds1 <n> <updown>
	(or vice-versa).
DS1 n Loss of Signal	Event Report LOS Problem. DS1	Correct the problem with the
	has LOS (Loss of Signal)	incoming DS1 signal, or use
		following CLI command to
		provision the DS1 as out of
		service:
		set ds1 <n> <updown>
DS1 n RAI (Yellow	Event Report Alarm Indication.	Correct the problem with the
Alarm)	DS1 is receiving RAI (Remote	incoming DS1 at the far end, or
	Alarm Indication), also known as	use following CLI command to
	Yellow Alarm. The far end	provision the DS1 as out of
	network element sends this alarm	service:
	when it declares Carrier Failure	set ds1 <n> <updown>
	Alarm (LOS, LOF, AIS).
DS1 n Transmit Failure	Event Report Framing Problem.	Replace the Quad T1 Framer card,
	Quad T1 Framer transmit DS1	or use following CLI command to
	circuit failure.	provision the DS1 as out of
		service:
		set ds1 <n> <updown>

Access Navigator - Release 1.8 August 2003 14-9