Carrier Access Access Navigator user manual Send Remote V35 Line Loopup

CLI Language Reference

CLI Command List

CA FDL
Command
					Access Bank II
Access			Framer		Time Slot
	DS1	T1
Navigator				Interchange

Framer

T1 Drop

Figure 18-20. Remote T1 Drop TSI Loopup

Security: Level 2 (operator)

Syntax: send remote <n> t1drop tsi loopup

Field

n

Description

DS1 number, 1 to 32

Example: send remote 9 t1drop tsi loopup

Message: Loop command sent to remote.

Send Remote V35 Line Loopup

NOTE: This command applies only to a remote Access Bank II connected to the Access Navigator by a DS1 using Carrier Access FDL management protocol. For normal operation, the loopback must be disabled by the send remote loopdown command.

NOTE: Only one port of the Access Bank II can be looped up at a time. If a loopup command is received for a second port, the first port will be looped down automatically before the second port is looped up.

NOTE: To check remote loopback status, use the read remote loopback command. See Read Remote Loopback on page 18-51.

Purpose: Sends an out-of-band(FDL) message to a remote Access Bank II over the Access Navigator DS1. It is used to verify V.35 signal processing.

When the operator enters a send remote command, the Access Navigator transmits a message over the Carrier Access FDL management channel of the drop DS1. The Access Navigator’s drop DS1 is the Access Bank’s T1 connection.

The send remote v35 line loopup command should cause the remote Access Bank II to perform a line loopback in the V.35 interface. This takes the received V.35

Access Navigator - Release 1.8 August 2003 18-91