Carrier Access Access Navigator Assign Primary and Secondary EOC, Set eoc primary nchnone

Provision GR-303 Service

Assign Primary and Secondary EOC

Assign Primary and Secondary EOC

1.Show current EOC settings with the following command: show eoc

The show command will produce a message showing the embedded operation channel (EOC) settings similar to the following:

Settings for EOC:	DS1	25,	Channel	12
Primary EOC:
Secondary EOC:	DS1	29,	Channel	12

NOTE: For proper operation, the EOC must be on Channel 12 and the TMC on Channel 24 of the DS1. The first switch DS1 (TermID = 1) in the GR-303 interface group must contain the primary EOC and TMC. The second DS1 (TermID = 2) must contain the secondary EOC and TMC. By default, DS1 #25 is TermID 1 and DS1 #29 is TermID 2. The show ds1 all command lists the DS1 TermIDs.

2.If switch EOC settings are correct, skip remaining steps.

NOTE: It is recommended that primary and secondary EOC and TMC be assigned to different Quad T1 Framer (QF) cards for added protection. In the event one QF card fails, the GR-303 switch will then be able to continue service using the redundant EOC and TMC on a different QF card. QF card #1 contains DS1 #1 to #4 contains DS1 #5 to #8, etc. By default, the primary EOC and TMC are on DS1 #25 and the secondary EOC and TMC are on DS1 #29.

3.Set EOC primary location with the following command:

set eoc primary <n:chnone>

Example:	set eoc primary 25:12
Example:	set eoc primary none

4.Set EOC secondary location with the following command: set eoc secondary <n:chnone>

Example:	set eoc secondary 29:12
Example:	set eoc secondary none

10-18 August 2003 Access Navigator - Release 1.8